How can I temporarily deactivate steps in DS?

Follow

You can make sure a step is not executed by disabling it.

 

▼Disabled "Test Value" step

1.png

 

There are 2 methods to disable a step:

・from the context menu

・from the "Basic" tab of the Step View

 

Please refer to the following explanations for each method.



Procedure

■Disable with the context menu

1. Select the step you want to disable.

2.png

 

2. Right-click it.

 

3. Click "Disable Step" in the context menu.

3.png



■Disable with the Step View

1. Select the step you want to disable.

1.png

 

2. Uncheck the "Enabled" box under the "Basic" tab of the Step View.

4.png

 

For more about steps in DS, please also refer to the following articles.

 

Notes

・Steps disabled in the Design Mode are also disabled in the Debug Mode.

・You can still enable the steps you have disabled, using the same procedure.

・You cannot disable some steps such as loops.

0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.